|
Gave it 4 out of 5 because I wish the vise could be adjusted for angle cuts, ie 45 degree. Still love it though.
The concept seems good. A nice concept, flawed in execution. I considered shims to effect a "kluge," but then there remains the second major flaw.
Unfortunately, my unit arrived with multiple flaws. The result is that a small lateral pressure on the saw handle deflects the blade as much as 1/8 inch. The ability to cut steel without all the problems of an abrasive cutoff saw, at a reasonable cost.
The single bolt attachment to the upper case of the saw is not rigid enough. The band saw mounts to the pivot arm at a single point with a single bolt, which is normally the front "T" handle. The pivot arm appears to have been improperly cast or machined, so that the setup geometry as specified in the manual was impossible to obtain.
Granted, better than hand held, but not acceptable to me. Returned.
After it is set, you can take the band saw off and reattach later, no adjustments needed.The only thing that would make it better if it could also cut 45 degree cuts as easily. Trying to get consistent true cuts by hand is frustrating, especially when you are creating a lot of expensive scrap metal in the process. After I purchased the Milwaukee bandsaw, I realized that most of the cuts I wanted were true 90s. (I've made a jig to hold the stock for 45s). Now I just secure my Milwaukee band saw in the arm and I'm good to go. When you first receive it, you need to get it adjusted for a true 90. Or, having a variable degree setting (like a miter saw) would be AWESOME. ;-)
It works ok. Takes a while to get everything square. The clamp can be a pain to use.
I like the table and it makes for perfect cuts with the saw. You must set up the saw to be at 90 degrees to the vise and square to the flat part of the table.Use a machinists square to set it up. To me, this is the only way to use a saw like the Milwaukee.
|
